This group RF modules contain : transmitter and receiver module，it can supply 4 channels to communicate，that's to say if you use them to control mini car，they have just four direction key。this is transmitter module：
This is corresponding receiver:
If you want to experiment these two module，only need to connect them to sensor shield by cables，for example you can connect the first channel of the transmitter module with the Arduino digital I/O pin 7，and the receiver to Arduino digital I/O pin 8：
I wish once push one button，RF transmitter module send the signal，and after the receiver module receive the signal，light the Arduino's LED。So you can connect Arduino digital I/O pin 2 with a digital button module，in order to receive the signal:
Download the program into Arduino:
int ledPin = 13;
int switchPin = 2;
int sendPin = 7;
int recvPin = 8;
int value = 0;
void setup() {
pinMode(switchPin, INPUT);
pinMode(recvPin, INPUT);
pinMode(ledPin, OUTPUT);
pinMode(sendPin, OUTPUT);
}
void loop() {
value = digitalRead(switchPin);
if (HIGH == value) {
digitalWrite(sendPin, HIGH);
} else {
digitalWrite(sendPin, LOW);
}
value = digitalRead(recvPin);
if (HIGH == value) {
digitalWrite(ledPin, HIGH);
} else {
digitalWrite(ledPin, LOW);
}
}
Copy Code
Once push one button，RF transmitter module send the signal，
and receiver module receive the signal，at last light the LED of pin 13。
.jpg)
.jpg)
.jpg)
.jpg)
