Arduino Digital Commom Button Module V2.0

We can build electronics projects just as easy as piling bricks. Arduino and community have made the programming much easier than ever before. How about some elixir on hardware part? Maybe it is not yet convenient to make complex interfaces, but we can at least start from the most commonly used modules.

By using electronic bricks, you may connect Arduino compatible boards easily with various digital, analog and I2C/Uart interfaces. These the breadboard-less firm connection are prepared to extensive modules like poteniometers, sensors, relays, servos...even buttons, just plug and play.

Each terminal module has buckled port with VCC, GND and Output, which has corresponding port on the sensing board, with a plain 2.54mm dual-female cable you may start playing already. Buckled brick cables are like cement for bricks, make the connections easier, secure and more professional looking.

It is very interesting Electronic Brick Module

This module can be used with Arduino Special Sensor Shield V4.0.
You can do some simple design about it，it support“plug and play”。
This module is a simple plugable terminal module, you can easily plug some other stuff into this without connect the wire to the terminal every time.

For most simple sensor module, usually having three poles interface are enough : GND、Power Source and Signal, therefore we have designed this general sensor module :
The left part of this module can connect with the sensor shield through the sensor cable, and the right part of this module can connect with sensor bricks such as infrared reflection switch as following :



So we can connect these sensor bricks with sensor shield,thus further to connect with Arduino :